150 opening data channel for file download

Opening ASCII mode data connection. Cannot open data connection. I encountered the above problem when I tried to use passive mode on the command line in Windows. I found the information I wanted by searching the materials: IE usually uses passive mode, while the command line utility (ftp command) always uses active mode.  · I am using an automated script for uploading files to a FTP server. The script did work fine in couple of machines. However, when I tried the same in one of the machines, it transferred up to MB of data and then it hanged showing a status response - .  · I can download file from Filezilla FTP to my GNS3 Router. i also can upload file from my PC to Filezilla server But () Opening data channel for file upload to server of "/DSCJPG" ()6/9/ AM - cisco () disconnected. Will anyone kindly tell me what is the problem? Top. botg Site Admin.

Opening ASCII mode data connection. Cannot open data connection. I encountered the above problem when I tried to use passive mode on the command line in Windows. I found the information I wanted by searching the materials: IE usually uses passive mode, while the command line utility (ftp command) always uses active mode. Using any commands such as dir cd or ls causes the Opening ASCII hang up. Using active FTP. Ports 20 and 21 set to allow traffic in both directions. I've tried removing the antivirus and firewalls and connecting, same issue. I've tried connecting with my personal laptop, same issue. Show activity on this post. You have most probably not opened the data connection ports on the firewall of the server (or have not forwarded the ports on NAT, if there's any). Check what ports the FTP server is using and open/forward them. Another problem is, that you have not configured a correct external IP address in the FTP server.

Opening data channel for file transfer. Transfer OK Transfer of jpg as binary data (, bytes, 82, bytes/sec, elapsed) completed at 6/9/09 PM PORT ,,0,2,, Port command successful STOR jpg Opening data channel for file transfer. Transfer OK. Using any commands such as dir cd or ls causes the Opening ASCII hang up. Using active FTP. Ports 20 and 21 set to allow traffic in both directions. I've tried removing the antivirus and firewalls and connecting, same issue. I've tried connecting with my personal laptop, same issue. Command: TYPE I Response: Type set to I Command: PASV Response: Entering Passive Mode (,7,63,37,98,) Command: RETR topfind247.co Response: Opening data channel for file download from server of "/topfind247.co" Response: Successfully transferred "/topfind247.co" Status: File transfer successful, transferred 5, bytes in 1 second.